My Wheels — Chapter 20
1972 Audi 100 LS

audi100My friends had a red one that really impressed me. They were antique dealers and the car had been part of an exchange involving furniture. “If another deal like that ever comes along”, I told them, “I’ll take it.” It did and I did.

That red Audi 100 LS was a two-door automatic. I think it was a year or two newer than the white four-door four-speed that I bought after it was swapped for an armoire. It was the build quality as much as anything that impressed me about the Audis. I commented more than once that it felt like the car was built by people who thought they might have to ride in it someday. The photo is from the internet. That’s not my car but it’s close. The only obvious differences are the fog lights and wide European style license plate area.

The car came with two invisible flaws. The first was a failing second gear synchronizer which, although it couldn’t be seen with eyes, was instantly apparent with a drive. Surprisingly, perhaps, it was almost instantly relegated to a mere inconvenience. Matching engine and gear speed was actually quite easy. With a brief pause in neutral and a restrained throttle blip, a shift to second was usually completed without even double-clutching. It quickly became second nature to me. The other flaw appeared infrequently but was much more than an inconvenience and was, at least indirectly, involved in the Audi’s demise.

The issue was carburetor icing. Under the right conditions, something in the carburetor would freeze and prevent the car from running. There were only a few time that this behavior left me stranded but, since those right conditions consisted mostly of wet and cold, the strandings made an impression. I can’t claim that my sources were all that reliable but, after some consulting and reading, I came to believe that the cause of my troubles was a warped plate in the carburetor. This was known to occur now and then and trigger the symptoms I was seeing. Whatever it was I was reading indicated that replacing the factory unit with a Weber was the thing to do.

The Weber carb and some other bits had to be ordered which in those days meant snail mail in both directions. I half recall starting the installation then delaying it to get one more connector or something but the swap was eventually made and the car ran fine but not for long.

audiwreckIt’s not at all clear to me what happened but, as is obvious from the photo, it wasn’t good. That really is my car. The official story is that I was drunk and lost control. I also lost my license for several months. I don’t dispute the official story but neither can I confirm it.

What I remember is this. I finished the carburetor swap and set out for a test drive. I stopped at a bar, had one drink, and left for home. I came to in a hospital emergency room. The police dropped me off at home.

Friends I had chatted with at the bar confirmed that I had left after one drink. The location of the wreck was between the bar and my home but not on the most direct route. My blood alcohol level was above the limit though not by much. It’s possible that I stopped at another bar, had another drink — or more — and was headed home from that second stop. It’s also possible that I didn’t take the shortest path home because I was trying out the new carb and that the one drink, scotch & ice, was responsible for my BAC. Even though mentioning it may seem like excuse hunting, it’s possible that something in the newly connected throttle linkage failed and contributed to the accident.

I’ll never know for sure what happened but I will forever be thankful that no one else was involved and that the only damage was to me, my car, and a little landscaping.

My Previous Wheels: Chapter 19 — 1970 Chevrolet Nova
My next Wheels: Chapter 21 — 1979 Chevrolet G10

2 thoughts on “My Wheels — Chapter 20
1972 Audi 100 LS

    • Yeah, digging out these pictures refreshed my marveling at my escape. “Some people claim that there’s a woman to blame, but I know, it’s my own damn fault.”

Leave a Reply to Jim Grey Cancel reply

Your email address will not be published. Required fields are marked *